Drivers & PC Utilities
This section contains articles and guides related to the RoboteQ PC Utilities and all the necessary drivers
In most cases, Windows will generally automatically install the necessary DFU Drivers with the install of Roborun+. However, in some cases the drivers are ...
Mon, 14 Jun, 2021 at 1:42 PM
There are cases when the DFU loader does not recognize the device, but we can see it at the device manager as STM32 DFU as the images below. In this...
Fri, 18 Mar, 2022 at 12:17 PM
Introduction Depending the screen-size and the resolution, the Roborun+ Utility might incorrectly show the parameters mixed or fragmented (Picture 1...
Wed, 6 Oct, 2021 at 3:25 PM
Introduction One common issue you could face with the RIOX Configuration utility is the Control and Power unit trees missing. The trees are files used ...
Tue, 12 Oct, 2021 at 3:47 PM
Some of our older controllers operating with firmware versions earlier than our 1.8d, will not be shown in the latest Roborun+ utilities. This is due to...
Mon, 1 Nov, 2021 at 2:00 PM
If a wrong firmware has been installed on the controller or the firmware upgrade process has been interrupted, the controller will crash and (most probably)...
Thu, 17 Feb, 2022 at 1:32 PM
The MGS1xxx, MGSW1xxx and MGSM1xxx are the three main series of Magnetic Sensors, produced by RoboteQ. The main use of this sensors is to acquire magnetic f...
Mon, 21 Mar, 2022 at 3:45 PM
There are some cases where Roborun will be unable to start and the following error will appear. We will receive notification messages as below. ...
Fri, 23 Sep, 2022 at 10:59 AM
Introduction Device Firmware Update (DFU) is a mechanism of updating the firmware of RoboteQ controllers through USB based on DFU 1.1 specifications. ...
Wed, 21 Sep, 2022 at 4:19 PM
Whenever we got STM32 software installed there is a chance that Windows will regard our controller as STM32 DFU and not STM device in DFU mode. This is quit...
Fri, 7 Oct, 2022 at 1:29 PM