F3 products

Hall Sinusoidal - Open Loop
Below are the basic steps required to run a motor in Open Loop by using its Hall sensors. Only the necessary information to run the motor will be provi...
Mon, 6 Feb, 2023 at 5:23 PM
Migration to 2.1 firmware guide - FOC and PID tuning
  2.1 firmware gives the ability to control the motor in sinusoidal switching mode with FOC (Field Oriented Control) that previously was not fully supporte...
Wed, 21 Sep, 2022 at 10:43 AM
How to configure AC induction motors - Simple Guide - F3 version
AC induction motors are reliable and cost-effective, factors that are very important when picking a fitting motor for an application. In the present guide w...
Mon, 10 Oct, 2022 at 11:27 AM
Closed Loop configuration - All sensors - F3 version
This guide will describe all the necessary steps to perform the configuration of the Closed Loop by using any of the supported motor sensors. Before that, a...
Mon, 10 Oct, 2022 at 10:42 AM
Hall + Encoder Sinusoidal - Open Loop
Quadrature A/B Encoder can be used in combination with Hall sensors to achieve the optimal motor's commutation. Hall sensors can give the absolute ...
Thu, 13 Oct, 2022 at 5:54 PM
SSI sinusoidal - Open Loop
Below are the basic steps required to run a motor in Open Loop by using its SSI sensors. Only the necessary information to run the motor will be provid...
Fri, 3 Feb, 2023 at 6:07 PM